Die-Pat - DPVRF1/H/2 VARIABLE PHASE POWER REGULATOR, PLUG IN POWER CONNECTOR BLOCK WITH PUSH FIT CONNECTIONS

Variable phase power regulator with RFi suppression

This rugged and compact on/off switch variable phase power regulator has a plug-in power connector block with push-fit connection has been designed to maximise thermal dissipation. Easy to install with a single mounting hole, and with an integral RFi network, this regulator is suitable for commercial kitchens and similar installations.

DPVRF1/H/2 is a variable phase angle power regulator designed for controlling single-phase mains power. Featuring a fully adjustable voltage output from 0 to 99% and is capable of handling high inrush currents safely. This variable phase power regulator also has an integral RFI filter network and is suitable for most quartz lamps and conventional resistive heating elements.

No additional heat sinks are required. It is recommended that the regulator be protected by a fuse or MCB to current I.E.E. regulations. This device also carries a CE mark and incorporates a filter (Standard type to emission levels BS EN 55022 Class A – Industrial) to address the EMC directive.

Variable phase power regulator features

• Triac limiting RMS, On state cycle - 40A
• Peak one cycle surge at 20ms - 400A
• Max forward volts drop - 10A
• Max load at 20°C ambient (no extra heatsink) - 15A
• Max unit operating temperature - 150°C
• Insolation voltage - 2500 V nms
• Operating voltage range: 0-220V, 50/60 Hz
• Integral RFI network
• Single hole mounting, 10mm diameter
• Suitable for commercial kitchens
• Shaft diameter, 6mm, Bush length, 7mm